Sonntag, 4. September 2011
WWG Roll Arena. It took me one afternoon, and I'm pretty pleased with the result. While gluing the corners of the arena itself, I seem to have made a few mm error, so the last corner I glued doesn't sit exactly on spot. This was sloppiness on my part, though, not a design problem.
The card drawer was way to flimsy for me. Again, the dimension was off by perhaps 1 mm, and this made pulling it out pretty tricky. I re-printed the drawer at 95% size to make sure it had a bit room on each side, and reinforced it with extra cardboard under the bottom. Now it works fine.
If the drawer-part only had two drawers, I would have added a third "layer" with two additional drawers... I'll see whether I do something like this with the next Arena I build.
As to the removable corner tops: I'm pretty curious as to what will go in there. I imagine a four-poster dice tower would be a good fit, so the dice could fall right in the arena space.
The card drawer was way to flimsy for me. Again, the dimension was off by perhaps 1 mm, and this made pulling it out pretty tricky. I re-printed the drawer at 95% size to make sure it had a bit room on each side, and reinforced it with extra cardboard under the bottom. Now it works fine.
If the drawer-part only had two drawers, I would have added a third "layer" with two additional drawers... I'll see whether I do something like this with the next Arena I build.
As to the removable corner tops: I'm pretty curious as to what will go in there. I imagine a four-poster dice tower would be a good fit, so the dice could fall right in the arena space.
Abonnieren
Posts (Atom)